Grasshopper 0.8.0006 available for download

Replies to This Discussion

Permalink Reply by David Robles on February 28, 2011 at 1:21pm

that was fast, thankyou!

• ▶ Reply

Permalink Reply by michael Peng on February 28, 2011 at 2:47pm

thanks David! install file has same name with previews version.

• ▶ Reply

Permalink Reply by TheChosenOne on February 28, 2011 at 3:39pm

Cool!

• ▶ Reply

Permalink Reply by Federico Escobar Salas on February 28, 2011 at 4:48pm

The link is damaged. It sends me to an error displayed by my browser.

• ▶ Reply

Permalink Reply by David Robles on February 28, 2011 at 4:57pm

http://download.rhino3d.com/Grasshopper/1.0/wip/rc/download/

• ▶ Reply

Permalink Reply by taz on February 28, 2011 at 5:10pm

The Transform data type is for geeks only. Rhino internally uses a 4x4 matrix to transform geometry. Unless you understand what all the numbers in the matrix mean, this is probably of no use to you.

Can you point out a reference for this?  My linear algebra is a bit fuzzy...

• ▶ Reply

Permalink Reply by Mateusz Zwierzycki on February 28, 2011 at 6:06pm

http://www.kxcad.net/Rhinoceros/RhinoScript/object_methods/transfor...

 

thats what i found about it... for a good start.

• ▶ Reply

Permalink Reply by Evert Amador on March 2, 2011 at 5:06am

Hi taz,

Have a look at  this

Cheers, Evert

• ▶ Reply

Permalink Reply by Luis Fraguada on March 2, 2011 at 5:32am

http://en.wikipedia.org/wiki/Transformation_matrix

• ▶ Reply

Permalink Reply by Evan Chakroff on March 1, 2011 at 6:02am

Great! Happy to have a new update to play with - but here's one small thing i've noticed already:

The new behavior of the number slider is really throwing a wrench into my workflow. I've got some pretty large definitions, and changing a single number sometimes has repercussions throughout the file.... the old version - where double-clicking brought up a dialog box where you could type in the desired number worked much better for me. These number scrollers with real-time updates are just killing my definitions. I would much prefer to be able to type in the max/min/value values as before.

 

 

Aside from this - great work, again!

• ▶ Reply

Permalink Reply by Danny Boyes on March 1, 2011 at 6:14am

If you now double click on the name area ie. slider by default, you still get the popup box as before. Then you can double click each scroller and manually enter the values you want. But have a look here at this discussion and add your 2 cents.

http://www.grasshopper3d.com/forum/topics/new-slider-comments

• ▶ Reply

Permalink Reply by Evan Chakroff on March 1, 2011 at 7:35pm

Ok. that works well enough. thanks!

• ▶ Reply

• ‹ Previous
• 1
• 2
• 3
• 4
• Next ›
• Page