Flip Surfaces

Replies to This Discussion

Permalink Reply by taz on March 26, 2010 at 4:49pm

Not directly...

One way would be to bake your surfaces and inspect them manually to see which ones are flipped.

Then try and devise a GH routine to keep the surfaces oriented they way you want using perhaps a guide surface or revising the way you construct your surfaces.

The bake, check again, etc.

• ▶ Reply

Permalink Reply by taz on March 26, 2010 at 5:17pm

You could also visualize the surface normals by displaying the vector. Then you wouldn't need to bake, but I find coloring the backside faces is any easier way (in Rhino) to see what's going on.

• ▶ Reply