Grasshopper

algorithmic modeling for Rhino

Fillet a box?

This is probably so simple it's stupid, but I'm new to GH and have not been able to find any solution.

I'm creating a 2Pt Box and would like to fillet its edges for a smoother box! What I don't understand is the Fillet component requires curves (which is logical), but how do I grab the curves/edges from the generated box? How do I get their output?


Any other way to go about it?


Thanks

Views: 5177

Replies to This Discussion

Permalink Reply by Leonardo Aguiar on July 4, 2017 at 11:39am

OK. I'm pretty sure I did it the hard way. Thanks for the tip. I will learn more about index pattern.

Attachments:
Permalink Reply by Pieter Segeren on July 24, 2017 at 10:28am

If somesome likes to try my FilletBox component (can chamfer too): it's in this blog post

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service