Grasshopper

algorithmic modeling for Rhino

fabrication?

friends, a little question...when i layout sections-curve to sheet cannot apply each section its point intersection...trying to do it with "list", but fails to make a universal definishn, because If I change number of sections, he don`t work.(( now all sections contain all points of all intersections))) help!

Views: 409

Attachments:

Replies to This Discussion

Permalink Reply by Manuel on December 6, 2009 at 7:29am
Permalink Reply by taz on December 7, 2009 at 12:16pm
You need to use data trees to make the number of intersections parametric.

Let me know if you have any questions!
Permalink Reply by KAKTYC on December 8, 2009 at 12:58am
...found answers to all my questions in your definition ))) thnks

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service