Fabrication!

Replies to This Discussion

Permalink Reply by Toussaint Jimenez Rojas on February 3, 2012 at 10:13am

i´m not to sure, but you can check this out 

http://www.tectonicasdigitales.com/?p=116

this definition allows to reconstruct double-curved surfaces based on triangular polygons, which develop into flat pieces to be sent after printing or cutting.

Its in Spanish so google translate it  if you cant catch something

• ▶ Reply

Permalink Reply by Derenik Baghramian on February 3, 2012 at 11:14am

Thank you for reply!
I want to surfaces for fabrication!but without triangls!i think i can use it !!!Thank you again!

• ▶ Reply

Permalink Reply by Toussaint Jimenez Rojas on February 3, 2012 at 11:54am

try to figuer out how to adapt it to your desire 

• ▶ Reply

Permalink Reply by Derenik Baghramian on February 3, 2012 at 12:33pm

Okay thank you !!!!i will post my dinal work when i finish it!

• ▶ Reply