algorithmic modeling for Rhino
I have a grid with small cylinders (representing structure) being extruded from the grid points. Currently the extrusion height of these cylinders is based on the distance of each grid point to an attractor. Instead, I want to set up the definition so that the extrusion height moves up a set distance moving away from the attractor.
Any help/advice would be greatly appreciated. I have attached my files below.
Thanks in advance,
Yeap. that's right. I have set up a slider to do this. in the snapshot the increment is 0.1 m but you change it to whatever value you like..
If I wanted to extrude a group of surfaces based on an attractor point, can I do the same as above using the extrude command and take the attractor point as the direction for extrusion?
I've been working with this definition and I am trying to do two things. One, I'd like to add multiple attractor points. Two, is there a way to set a vertical limit on the extrusion while still keeping the controlled stepping with the cylinders? Has anyone attempted or has successfully achieved this?
I want to do the same! Did you find a solution?