exclude circles

Replies to This Discussion

Permalink Reply by Arturo Steinberg on May 28, 2012 at 11:18pm

What did you bake to make the circles get to rhino?

If you used the dispatch component, it still have the whole bunch, so that could be the reason.

Try connecting a Geometry component at the end and bake that.

Cheers!

• ▶ Reply

Permalink Reply by David Rutten on May 29, 2012 at 1:21am

Hi Andrea,

I can't see a mistake in your images, can you post the gh and image files I need to reproduce this?

--

David Rutten

david@mcneel.com

Poprad, Slovakia

• ▶ Reply

Permalink Reply by andrea macruz on May 29, 2012 at 8:34am

Thank you David, I just posted the definition on the end of this page.

• ▶ Reply

Permalink Reply by Danny Boyes on May 29, 2012 at 2:45am

All of your circles' areas (Shown in the panel) are less than 10 some where in the order of 0.00001 to 0.00005 so every output is True and in Cull Pattern the Trues are kept.

The panel is showing the number in scientific notation see here for a further explanation of this: 

http://www.grasshopper3d.com/forum/topics/formatting-numbers-in-gra...

• ▶ Reply

Permalink Reply by andrea macruz on May 29, 2012 at 7:05am

Thank you all for the answers…

I think maybe Danny is right-the numbers are to small- but anyway here it goes the definition and picture.

Attachments:

• panel 06_t01_r02.gh, 2.2 MB
• bomJesus_p1H.jpg, 990 KB

• ▶ Reply

Permalink Reply by andrea macruz on May 29, 2012 at 8:30am

I just did what Danny told me but still I didn’t get it…

Here is the new definition.

Attachments:

• panel 06_t01_r04.gh, 2.2 MB
• bomJesus_p1H.jpg, 990 KB

• ▶ Reply