Error Message trying to install Grasshopper

I am trying to load Grasshopper into Rhino 4 on the windows side of my mac and am gitting error messages: I have .NET 3.5

In the Windows control panals the Grasshopper download does not register any file size?

▶ Reply to This

Replies to This Discussion

Permalink Reply by David Rutten on April 7, 2012 at 2:11pm

Hi Malachi,

the second error (side-by-side configuration) is due to missing Microsoft Runtimes. Please follow the instructions on this page and hopefully the first error will go away too, if it doesn't, let us know.

David Rutten

david@mcneel.com

Poprad, Slovakia

▶ Reply

Permalink Reply by Malachi Payne on April 7, 2012 at 3:24pm

No luck... same errors???

▶ Reply

Permalink Reply by David Rutten on April 7, 2012 at 3:53pm

Are you absolutely sure you installed the 32-bit ones, not the 64-bit ones? The bit-depth of your operating system does not matter, you always need 32-bit runtimes for Rhino4.

David Rutten

david@mcneel.com

Poprad, Slovakia

▶ Reply

Permalink Reply by Danny Boyes on April 7, 2012 at 4:25pm

i have seen a number of mac users have success after installing the 64-bit version first and then instal the 32-bit after

▶ Reply

Permalink Reply by Malachi Payne on April 7, 2012 at 10:04pm

OOOH... Was that all??? Got it!!!

Thx Dave

▶ Reply

Permalink Reply by Les Taylor on November 20, 2012 at 5:34pm

Following the suggestions on this thread has worked (as a solution)on one of two of my computers but, with regards to my second installation on computer two I'm presented with the following errors:

I'm wondering if I should hose/uninstall the redistributable C++ 2005 currently loaded? and then try reinstalling vcredist_x86.exe or does it require the .msi installer? any suggestions?

Best wishes,

Les

Attachments:

▶ Reply

Permalink Reply by Arquimatias on April 8, 2012 at 4:29pm

I had that problem too, updating runtimes solved it. Thanks.

▶ Reply

Permalink Reply by David keast on April 23, 2012 at 9:15pm

Hi David,

I have almost an identical problem however after I install the runtimes the problem still exists. I am running a 32 bit PC and Rhino version 4.0 SR9, 9 March 2011 Evaluation. Have you got any ideas as to what I am doing wrong?

Thanks,

Dave