Grasshopper

algorithmic modeling for Rhino

I have prepared a file for Energy Simulation for a single room. The last time I used the file it was running the simulation. But now when I opened it again it is showing fatal error.

1. The simulation has not run correctly because of this severe error:
** Severe ** IP: IDF line~11 Did not find "ProgramControl" in list of Objects

1. The simulation has failed because of this fatal error:
** Fatal ** IP: Errors occurred on processing IDF file. Preceding condition(s) cause termination.

What can I do to run this simulation again ? 

Views: 483

Replies to This Discussion

Mansi, You have to send your questions about Honeybee to Ladybug forum:

http://www.grasshopper3d.com/group/ladybug/forum

Mostapha

I will repost it at the right forum. 

Sorry for the confusion. 

Thanks 

Mansi

RSS

About

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service