Grasshopper

algorithmic modeling for Rhino

duplicate points

I think there might be an issue in 0.9.0056 with the duplicate points component 

even just feeding in a list of two coincident points (tolerance 1, unit model mm) throws an exception 

regards

Views: 539

Replies to This Discussion

Permalink Reply by David Rutten on January 27, 2014 at 8:06am

This will be fixed in the next release. Thanks for reporting.

--

David Rutten

david@mcneel.com

Permalink Reply by jozze on October 17, 2014 at 1:14pm

Hi,

Has this issue already been tamed?

I'm tasting the same problem with .9.0075.

regards

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service