generative modeling for Rhino
This might be very easy but I cannot achieve it so any help would be very greatfull
I have a trimmed surface which i want to divide as shown on the attached image.
Basically I have a trimmed surface where i would need the division points to travel from edge 1 to edge 2 while edge 3 & 4 would need to act as attractor curves. So I would also need points on edges 3 & 4.
ps. I have also attached the rhino file
Thanks in advance
I'll study your solution right away!
Is there a reason why the points on the two shorter edges are not equally distanced?