Divide circle by number error

Replies to This Discussion

Permalink Reply by Jon Mirtschin on June 15, 2011 at 6:47am

Hi David,

 

I hope you're well.

Strange, I can change the slider to 4083 and it works ok here.  But I've seen this before so I can offer a possible work around (but not a solution).  Translating the circle from origin, dividing, and translating the points back worked for me in the past.  If I recall correctly, this seemed to be an issue in rhino common as I tried scripting the steps and it was the same problem.

Hope it might help you in the short term, I'm sure David R can advise.

Cheers,

 

Jon

 

• ▶ Reply

Permalink Reply by David Hines on June 15, 2011 at 8:37am

Hi Jon,

I'm good, hope your well. Thanks for the note, couldn't quite follow your steps.

I ended up doing the following:

Line SDL (L=122000) / Rotate (rad(A) = range 0-355, of N=71) / end points / intcrv (D=3).

Attached.

Its a curve not a circle, but it gives me the points and csetout I need.

David

 

 

Attachments:

• divide_circle_resolve.ghx, 100 KB
• divide_resolve.JPG, 168 KB

• ▶ Reply

Permalink Reply by Jon Mirtschin on June 15, 2011 at 9:30am

Hi David,

 

Try the attached, this was how I got around the situation when I encountered it (can't remember if I reported it).

 

Hope it helps,

 

Jon

Attachments:

• divide_circle workaround.gh, 11 KB

• ▶ Reply

Permalink Reply by David Hines on June 15, 2011 at 10:12am

Thanks, it still ended up dropping the points around the circle even with this setup.

Lets see if David can reply, - once he's back from deserved holidays.!

• ▶ Reply

Permalink Reply by David Rutten on June 15, 2011 at 10:26am

I'm back. I'll be looking into this soon.

 

--

David Rutten

david@mcneel.com

Poprad, Slovakia

• ▶ Reply