distort a hexagon pattern

Replies to This Discussion

Permalink Reply by Evert Amador on September 25, 2010 at 8:52am

Hi Liam,

Really nice pattern.
How do you want to distort the pattern?
Do you want to follow the mesh/surface?
What input would the control points of the mesh would have?

Cheers

Evert

• ▶ Reply

Permalink Reply by Liam Morrow on September 25, 2010 at 10:01am

I want to have the hexagon patterns to map to a surface then the control points(on the surface) to distort the pattern i already have. I'm not even sure if this is possible, I might have to start from the beginning of the definition and rewrite the logic. The problem is matching a surface's control points to a hexagons.

• ▶ Reply

Permalink Reply by Evert Amador on September 25, 2010 at 11:25am

Hi Liam,

It is possible, Have a look at the enclosed this is similar to what you want!

I'll have a look at it later as I need to go out.

Cheers

Evert

Attachments:

• newhexcomponantbuild02_080110Evert.png, 320 KB
• newhexcomponantbuild02_0729010Evert.ghx, 1 MB

• ▶ Reply

Permalink Reply by Liam Morrow on September 25, 2010 at 11:51am

I like the definition. For my own however, I was looking for a distortion similar to this.

Attachments:

• grid-Converted2.jpg, 93 KB

• ▶ Reply

Permalink Reply by Evert Amador on September 25, 2010 at 3:38pm

Hi,

Please look at the enclosed, this can be a start. You need to rebuild the target surface and move its control points to change the pattern.

Cheers

Evert

Attachments:

• Distort_A_Hexagonal_Pattern.ghx, 187 KB
• Distort_A_Hexagonal_Pattern.png, 19 KB

• ▶ Reply

Permalink Reply by Juan Alberto Galicia Osorno on March 30, 2011 at 12:57pm

I'm curious....where did you find those pictures?

• ▶ Reply