Deadline - Help: moving points.

Hi everyone, i Have a big deadline tomorrow and lots of ambitious ideas I would like try and complete by tomorrow morning...

Im new to grasshopper, so these questions may be very basic.

How can I move the start and end points to the 2 most inner points?

Tags: arc, moving, points

Attachments:

1.jpg, 132 KB

▶ Reply to This

Replies to This Discussion

Permalink Reply by Danny Boyes on November 26, 2009 at 3:07pm

Hi Noam,

Instead of offsetting the original curve and moving its points back in, try generating the arcs from three points and only transforming the centre point.

▶ Reply

Permalink Reply by Noah H on November 26, 2009 at 4:14pm

thanks so much, really helps.
I was wondering if you can tell me how to duplicate on a slider (to duplicate it numberous times) so that it looks slightly like the photoshop image that I have attached.

thanks again.

Attachments:

2.jpg, 27 KB

▶ Reply

Permalink Reply by Danny Boyes on November 27, 2009 at 4:07am

Try this:

Attachments:

FibArcs.ghx, 258 KB

▶ Reply

Permalink Reply by Noah H on November 26, 2009 at 4:18pm

also, could i just add, how can the arches move so that the mid point on the smallest arch would sit on the mid point on the last curve of the previosu batch. Not sure how clear that is but basicaaly as it is in the image.