cutting slides from a volume

Replies to This Discussion

Permalink Reply by Hannes Löschke on February 22, 2012 at 4:31am

Create a bunch of planes and intersect them with your geometry. Use the section curves to build your slices.

• ▶ Reply

Permalink Reply by aw on February 22, 2012 at 9:13am

thanks for your help!!coz i am a new user, can u plz further explain on it, i really not  that understand.If anyone get the tutorials/definitions in working on it, plz share with me, many thanks. 

• ▶ Reply

Permalink Reply by Danny Boyes on February 22, 2012 at 10:59am

Try this:

File written in version 0.8.0066

Attachments:

• SectioningExample.gh, 30 KB

• ▶ Reply

Permalink Reply by aw on February 22, 2012 at 12:27pm

danny, thank you so much!!!ur explanation is really helpful!!!:)

• ▶ Reply

Permalink Reply by Michael Pryor on February 23, 2012 at 1:06pm

also you can try the contour components.

• ▶ Reply

Permalink Reply by aw on February 23, 2012 at 12:54pm

my GH is not 0.80066 and i try to to download this version but failed. My version now using is 0101211, how can i open your file? thanks. 

• ▶ Reply

Permalink Reply by Michael Pryor on February 23, 2012 at 1:04pm

get the newest one. http://download.rhino3d.com/Grasshopper/1.0/wip/download/

• ▶ Reply

Permalink Reply by aw on February 23, 2012 at 1:07pm

coz i dont hav rhino 5.0, i am using 4.0, it doesn't support GH0.80066

• ▶ Reply

Permalink Reply by aw on February 23, 2012 at 1:08pm

can anybody help transfer the file into an older version so i can open??

• ▶ Reply

Permalink Reply by Luis Fraguada on February 23, 2012 at 1:32pm

Rhino 4 service release 9 supports 080066 just fine.  I use it every day, as well as Rhino 5...

• ▶ Reply

Permalink Reply by Michael Pryor on February 23, 2012 at 1:56pm

me as well, on SR8 :)

Permalink Reply by RWNB on February 24, 2012 at 4:22am

hi danny,
it is also possible to vary the thickness of the slices,
dependent on attractors?

• ▶ Reply

• ‹ Previous
• 1
• 2
• Next ›
• Page