Grasshopper

generative modeling for Rhino

Curves Intersecting a Surface

Hi All! I am trying to use the curves contained within a rectangle for structural analysis. See below:

I am using the SCX module (intersection between surface and curves). The problem is: sometimes the function misses a line (see above). Is there a better way to do this seeing as how what I'm doing doesn't always work?

Views: 229

Attachments:

▶ Reply to This

Replies to This Discussion

Permalink Reply by Michael Pryor on April 29, 2012 at 7:50pm

have you tried it out with project?

Permalink Reply by Dave on April 29, 2012 at 7:52pm

Thanks for the reply! Although I am sure this would be easy, I am so inexperienced with surfaces.... I'm not really sure how to do that.

Permalink Reply by Michael Pryor on April 29, 2012 at 8:21pm

there is a component called project, It projects curves onto a brep. 

Permalink Reply by Dave on April 29, 2012 at 10:11pm

If only I understood BREP. I have a surface here. Have you looked at the attached file?

Permalink Reply by Michael Pryor on April 29, 2012 at 10:16pm

brep = surface or  polysurface. so surface works as brep. plug your curves and your surface (brep) into project

RSS

Translate

Search Grasshopper

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2013   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service