generative modeling for Rhino
i am trying to make a curve on a surface, using the endpoints, centre and endpoint of the edge of a subsurface, and points along it, to interpolate a curve.
but even when i add more points, when the base surface is highly curved, the lines will not follow the surface closely enough.
Is there another way to achieve a curve that more closely follows the surface? Orshould i change the approach altogether? Perhaps with U/V divisions?
(Also, I offset a surface and railed along it to create an extrusion?)
Have you tried it with the boxmorph componet?
thanks a lot for your reply!
I haven't got one before, but I was told that was the rambling/poor quality of my earlier posts...
v noobish of me, the box morph looks good, I will have a look.
Thanks again, very appreciated.