Culling

Hi I have generated a definition that divides a line into segments that represent different locations of a concrete box beam.

Geometry is based as follows:

• overall length 35m (35000)

• End blocks 1800mm, these have a different geometric properties

• 1st and last troughs are 6500mm

• Internal troughs 3No. work out around 6133mm

• the internal troughs have a diaphragm between them 180mm, hence the intersecting points.

The definition appears ok, however i seem to have been unable to cull all the points my sketch attached hopefully indicates the points that I have been unable to cull.

Any ideas greatly appreciated.