Grasshopper

algorithmic modeling for Rhino

creating a polyline

I have very simple problem: a problem with creating a polyline. Either I try to create polyline from points or join the curves - I am unable to connect more than one point to polyline component and if I try, the previous one disconnects. And same phenomena occurs with 'join curves'. 

1) I connect first point to polyline component.

2) I connect next point to polyline component and the previous one disconnects.

Views: 5317

Replies to This Discussion

Permalink Reply by David Rutten on September 10, 2014 at 2:26pm

Hold down SHIFT to create more than one connection.

Permalink Reply by Mateusz Zwierzycki on September 10, 2014 at 2:31pm
Permalink Reply by Selma Tokartczuk on September 10, 2014 at 2:36pm

oh, well, that was stupid. Thank you so much !

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service