algorithmic modeling for Rhino
copy trim bug
Hi.
I dont't know if it is a bug, or maybe I did something wrong, but while using the copy trim command it copys my pattern (right) but on the surface it is slightly offseted from the edges.
Could anyone help?
Views: 713
- Attachments:
-
-
Copy trim.gh, 10 KB -
Copz trim.png, 732 KB
-
Replies to This Discussion
-
Permalink Reply by Hyungsoo Kim on
-
Hi.
You didn't internalise your target surface geometry, anyway, check attached.
- Attachments:
-
-
Copytrim_re.gh, 15 KB
-
-
About
Welcome to
Grasshopper
Translate
Search
Photos
Videos
-
Scaling Tower
Added by Parametric House 0 Comments 0 Likes
-
Field Trap
Added by Parametric House 0 Comments 0 Likes
-
Subd Bridge
Added by Parametric House 0 Comments 0 Likes
© 2024 Created by Scott Davidson.
Powered by
