copia random

Replies to This Discussion

Permalink Reply by djordje on July 19, 2012 at 3:19pm

I used "Y vector" for direction to which the lines will be moved.

Instead of that, you can use any other vector.

Also, you need to "import" the line from Rhino to Grasshopper. Do that by right clicking on "Curve" parameter, and "Set one line". Then select the desired line you want to copy from Rhino.

Attachments:

• copy random lines.gh, 3 KB

• ▶ Reply

Permalink Reply by alessandro on July 20, 2012 at 11:10am

thanks

• ▶ Reply

Permalink Reply by Michael Pryor on July 19, 2012 at 3:39pm

Here is a way to cap the random distances at lowest and highest values. Also, to insure the distances between is measured from the previous line, and so on.

Attachments:

• random divide low and high cap.gh, 3 KB

• ▶ Reply

Permalink Reply by djordje on July 19, 2012 at 3:54pm

I learned something too. I did not know about that Mass addition component.

Thank you Micheal

• ▶ Reply

Permalink Reply by alessandro on July 20, 2012 at 11:11am

thanks

• ▶ Reply