Grasshopper

algorithmic modeling for Rhino

I have two points and I connect them into a straight line, I continue to edit that line into a curve with the gumball tool. When I move the first 2 points or the 'Rebuild Curve', the curve goes back to the straight line. I have to start over again. how to overcome this?

video description

Views: 1083

Attachments:

Replies to This Discussion

Whenever the input is changed, the gumball is reset. This component works well as a source for an algorithm, not an intermediate or final point.
This implementation is not what you expect, do not expect it to work like Rhino's gumball, GH does not allow it.

You can get what you want with a bit of code. The second parameter gives the transformations, can be stored before reset and reapplied after reset.

You can get what you want with a bit of code. The second parameter gives the transformations, can be stored before reset and reapplied after reset.

 
Examples of this

I can do it for 40 euros without exclusive use. Send me an email to dga_3@hotmail.com if you are interested.

ok. I will consider this issue

RSS

About

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service