Grasshopper

algorithmic modeling for Rhino

Collection of Breps into lists based on faces

Hello All! 

Trying to separate a collection of BREPs into Lists based on the number of faces on the individual geometries.

I have extruded a series of hexagons, but because of the base surface some of the geometry got simplified to either 5 sided or 4 sided extrusions. 

I deBrep, once there I see that its outputting with a set of values where N = 8, N = 10, and N = 12. I am assuming this is how I want to divide it up but I'm not sure where to go from there or if my train of thought makes sense.

Any and all help would be greatly appreciated! 

Views: 626

Attachments:

Replies to This Discussion

Permalink Reply by Hyungsoo Kim on July 12, 2017 at 4:33am

Check attachment.

Attachments:
Permalink Reply by Michelle Htar on July 12, 2017 at 4:54am

Wow! Thank you so much. 

Sorry for asking, once it indexes the instances, how can I have the branches as 3 separate lists? 

Permalink Reply by Hyungsoo Kim on July 12, 2017 at 4:57am

Try "Explode Tree".(Sets-->Tree-->Explode Tree)

Permalink Reply by Michelle Htar on July 12, 2017 at 5:13am

Yes! That worked! Thank you so much for you help, much appreciated! 

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service