Cluster question

Replies to This Discussion

Permalink Reply by Danny Boyes on February 22, 2012 at 5:59am

There is a bug regarding this. To overcome it simply disconnect all sliders and Param components leaving just the cluster arrows from the inputs and outputs.

After you cluster you will be left with some error wires from the Canvas Origin but these go away if you cut and paste the cluster.

• ▶ Reply

Permalink Reply by Atsuo Nakajima on February 23, 2012 at 12:00am

Hi Danny Boyes,

Thank you, it works.

I found some component sets can be created correctly as bellow, and others cannot be.

It depends on component sets.

Anyway your workaround solves.

Thanks again.

• ▶ Reply