Close surface

Replies to This Discussion

Permalink Reply by Danny Boyes on May 23, 2012 at 4:42am

I would approach this by splitting* the "Boundary" curve at the points that best resemble the corners to create 4 curves. Then using the two longitudinally orientated curves as Rails I would sweep the rest as sections.

*note in grasshopper Shattering is the component for this

.............

I'm disappointed that your profile picture isn't something more like this :)

• ▶ Reply

Permalink Reply by SimonTempler on May 23, 2012 at 4:51am

Many thx! I am quite new to grasshopper just wanted to know if there is a less time consuming way to achieve this.

ok, I will consider changing profile pic :)

• ▶ Reply