circle into squares and hight changes

Replies to This Discussion

Permalink Reply by Pieter Segeren on March 6, 2011 at 2:41pm

Hi Eva, I'd like to try to help you out, so I looked at your definition. I think you need to rephrase your question because I don't understand what you mean...

• ▶ Reply

Permalink Reply by Eva on March 6, 2011 at 3:06pm

Hi Pieter,

Thank you very much for help. So, now I have circles, I need squares instead, this I managed to fix I put polygon instead of circle. And now I want to change the hight of the volumes. For example, if I have an attractor and it could influence on the the hight changes. Or if it is possible without attractor would be great.

• ▶ Reply

Permalink Reply by Pieter Segeren on March 6, 2011 at 5:10pm

an attractor point you mean?
If yes: use distance component, to measure the distance(s) from attractor point to the points of your grid, then use these to control the extrusion height.
If no: how would you like to control the heights?

• ▶ Reply

Permalink Reply by Chris Tietjen on March 6, 2011 at 6:31pm

Hi Eva,

I hope this helps a little bit.  It could be modified to include the use of an attractor point to control height.

Chris

Attachments:

• skyscaper.ghx, 158 KB

• ▶ Reply