algorithmic modeling for Rhino
Change tolerance for one component and not the whole file?
Hi Guys,
Is there a way to change the Rhino tolerance specifically for one Grasshopper component? For example a "curve curve intersect" component could use a tolerance of 0.1mm when the overall Rhino tolerance is still 0.01mm.
If that's not possible it might be good to add a "tolerance" input to all the intersect components?
Many thanks,
Arthur
Views: 756
Replies to This Discussion
-
Permalink Reply by djordje on
-
- Attachments:
-
-
intersect_crv_tol.gh, 10 KB -
intersect_crv_tol.3dm, 37 KB
-
-
About
Welcome to
Grasshopper
Translate
Search
Photos
Videos
-
Subd Bridge
Added by Parametric House 0 Comments 0 Likes
-
Twisted Groove
Added by Parametric House 0 Comments 0 Likes
© 2024 Created by Scott Davidson.
Powered by
Hi Arthur,
Try this:
Distance between the lines from attached .3dm file, is 1.0.
It requires ghpython component installed.