Centre point of Subsurfaces

Replies to This Discussion

Permalink Reply by Adam on June 24, 2012 at 6:37am

Hi Jyoti, one simple way to find the mid point of each subdivision is by using Evaluate Surface. When You edit component you might setup U and V parameters to 0.5 and remember to reparametrize input S.

If u don't need a plane of each surface just use Area component. It has center point defined on output.

All best

• ▶ Reply

Permalink Reply by JYOTI SHARMA on June 24, 2012 at 7:22am

Thanks Adam...It worked really well..

• ▶ Reply