algorithmic modeling for Rhino
The only thing I can glean from the image, is that the capped surface and the cylinder do not match parameters so it might be a tolerance issue with the boolean operation. But otherwise I couldn't say why this is happening with this particular case.
As with everything in GH there is usually more than one way to get the results you want. Instead of capping a cylinder, create a planar surface out of the circle and then extrude the surface to create your solid pipe. Pass these into your Boolean operation and see if you get anything better.
Welcome to
Grasshopper
Added by morteza khorsand 0 Comments 0 Likes
Added by Parametric House 0 Comments 0 Likes
Added by morteza khorsand 0 Comments 0 Likes
Added by morteza khorsand 0 Comments 0 Likes
© 2024 Created by Scott Davidson. Powered by