generative modeling for Rhino
Brep help
Hey guys, can anyone tell me how to triangulate a simple brep/polysurface with the help of Grasshopper? It seems very basic but somehow I am unable to crack it. May be 'cos m new to Grasshopper.
Thnx.
Views: 168
Replies to This Discussion
-
Permalink Reply by Danny Boyes on -
Can you be more specific? maybe post a sketch or Rhino example of what you want to achieve.
-
Permalink Reply by tiqué on -
the thing is that i used the panelling tools to generate a set of panels on a surface. hence i have an extruded polysurf as a panel. now when i proliferate it on the surface, according to the surf modulation it spreads so obviously the panels will be non planar at places to achieve the curve... which lands me in a new problem to how to triangulate this panel to make it planar. hope m clear.
Thnx.
-
Permalink Reply by Danny Boyes on
-
Is the surface made up of individual quads or do you need to panel a single surface first?
-
Permalink Reply by tiqué on
-
the red thing is a single panel output on the base surface... i started off with a 3d box as a panel
-
Permalink Reply by Danny Boyes on
-
sorry to take so long, busy at work.
Shift List could be one way to achieve these results
- Attachments:
-
-
Triangulate.gh, 12 KB
-
-
Permalink Reply by Danny Boyes on
-
I was creating surfaces to demonstrate an example on. Unless you provide some files I cannot tailor make anything that is going to work straight out of the box for you. You will have to figure out how your model fits in with this definition.
-
Permalink Reply by tiqué on
-
Danny, i hv attached the files which i m working on. if possible have a look. appreciate it. from what i can see theres some problem in the formation of the pline... seems like its not taking into consideration all points.
- Attachments:
-
-
panel triangulate trial.3dm, 69 KB
-
panel triangulate.gh, 11 KB
-
Translate
Search Grasshopper
Photos
Videos
© 2013 Created by Scott Davidson.
Powered by
