algorithmic modeling for Rhino
hi All,
as rabbit and it's L-system is not yet developed for newer versions of GH i'm wondering how would it be possible to make use of hoopsnake for branching. I'm doing branch column which has circular section. At some point i found out that this might need some loop to make it more effective in case of any further changes of parameters.
cheers
Adam Chalupski
Tags:
are you looking for a treestructure?
not with hoopsnake yet, but maybe somthing to start from
http://www.grasshopper3d.com/forum/topics/trim-3d-lsystem-tree-bran...
Best Regards
DeDackel
Circle version will be "a bit" more complex since the number of points in every next level of the tree grows different then in the "square version".
Basicly, i want every branch to always split in two others. In .ghx example i found the right distribution of points but i'm i couldn't find the good solution of how to connect them with the lines to make the branches.
That will be only half way since that solution creates the tree which is "empty" inside. I would like it to distribute points on every level evenly (or close to evenly) on entire surface of the circles.
that solution makes doing branching much faster ! I found a little bit of mistery in that code and cannot run the loop. It's not clear to me where exactly 'tree branch'>'path' and 'flat'>'path' are connected to. I just pluged them to the HS counter output but it still creates an error.
it's also interesting how does modulus division works here. I put integer '2' as a divisor.
thank You sistemiq for interest in that topic !
Oops yeah the screenshot hides some details, here is the source.
The tree components are used to separate and retrieve the constructed lines and the current points in 2 branches ({0} and {1}).
Hey,
here is no Hoopsnake in it, but the circular bending is working :-)
Best Regards
DeDackel
Added by UTB01 0 Comments 0 Likes
Added by David Bachman 0 Comments 0 Likes
© 2017 Created by Scott Davidson. Powered by