generative modeling for Rhino
I am trying to create floor slabs that link 3 towers. I will also use the edges of the floor slabs to loft a building skin between the outer towers (see diagram below). I have tried a couple different ways to do this:
Method 1 - create a bounding curve around the towers at each level that I want a floorslab (every 3rd floor above the base levels), then loft for skin .. and trim somehow btw the two outer towers
Method 2 - create a shrink-wrap definition to wrap all three towers, then derive the contours for floor slabs.
I cant seem to get either to work at all.
FYI: I want to try to make the building skin to be between the outer towers, then loft horizontally when it comes close to the base levels.
I would really appreciate any help people can provide. thanks!
There's a still a few bugs in it, but how about the attached?
thank you so much... i think that will work great... and i will show you how it turns out.
just one question.... how do i input 3 curves on the same plane (essentially the same # within each list) into the curves component from the 3 sets of curves?
trying to use the grafting component, but no luck so far...
and for some reason, the number of curves in the lists is double what I think it should be... for instance, if I create a series of 20 curves (20 stories of the building), the output at the end of the definition says "40 locally defined values" ... not sure if this is a problem...