Baking problems ....

Hello people, recently i had some problems with a file because the grasshopper preview aloud me to see the entire objet in the screen, but when i try to bake it it just bake some of them randomly, i don´t know what is the problem, but the file is quite simple.

Please somebody help me...

i post here al the files to let you try

thanks

Tags: bake, baking, grasshopper

Attachments:

geometrical lamp.ghx, 523 KB
Captura de pantalla 2010-03-22 a las 19.41.26.png, 1.1 MB

▶ Reply to This

Replies to This Discussion

Permalink Reply by Giulio Piacentino on March 23, 2010 at 3:46am

Hi Pablo,

i tried changing a bit the definition and now it seems to be a bit more lightweight. The changes are:
- the polylines have been exploded into lines before projecting, as this allows better piping
- list management has changed in the project component. Now one sphere is used with all projections, and all curves are projected in two directions. You might review the concept of tree, if what happens is not very clear.

I used version 0.6.0059, you might need to download that version, too.
Hope this helps,

- Giulio
___________________________
giulio@mcneel.com
McNeel Europe - Barcelona

Attachments:

geometricallamp-01.ghx, 546 KB

▶ Reply

Permalink Reply by Pablo0o0oo0o000oo on March 23, 2010 at 10:18am

Ciao Giulio!
first of all thank you for your help, but I´ve been trying the file and there is still a problem with it.
The thing is that one of the curves doesn´t project properly yet, and i tried every thing i know.I like to use GH because of his maths perfection,and i don´t like when this happens to me,I need your help again for this.
Thank you very much again!!

Attachments:

geometricallamp02.ghx, 724 KB

▶ Reply

Permalink Reply by Giulio Piacentino on March 23, 2010 at 12:00pm

I see, sure we can make another step together...
- there was one point too much in the last "group"
- the intersector might occasionally fail if the line we are projecting is exactly touching the seam of the sphere
This file here addresses both these points, so all pipes are valid

- Giulio

Attachments:

geometricallamp03.ghx, 606 KB

▶ Reply

Permalink Reply by Pablo0o0oo0o000oo on March 23, 2010 at 12:15pm

thanks again Giulio, now i understand the problem,we have to be careful with the objets seams because it can make data lose...
i was looking for the answer on the net, but no one knew enough to tell me this

thanks again

Pablo