appearence (=mesh settings) of grasshopper surfaces in the rhino viewport

Replies to This Discussion

Permalink Reply by taz on April 22, 2010 at 9:30am

NURBS surfaces or meshes?

If it's NURBS you could try applying a color or material. That tends to make things show up better, but you can't adjust the default resolution of the preview geometry.

If it's meshes you can specify whatever custom mesh settings you want. Mesh > Util > Custom

• ▶ Reply

Permalink Reply by roberto gagliano on April 22, 2010 at 10:18am

it´s nurbs
thanks for the tip, i will try

• ▶ Reply

Permalink Reply by Danny Boyes on April 22, 2010 at 10:22am

If it is still not up to scratch, you could make a mesh based on your Nurbs surface with Mesh BRep Component and plug the custom settings component into it to have better control over the display mesh.

• ▶ Reply

Permalink Reply by roberto gagliano on April 23, 2010 at 12:21am

right what i was searching.
thanks!

• ▶ Reply

Permalink Reply by Lauge Brixvold on November 29, 2011 at 12:44am

I've been looking for the same, is this really still the only way to go?

Seems a bit unrhino like not to have the possibility to customize the interface.

 

Thanks

• ▶ Reply

Permalink Reply by David Rutten on November 29, 2011 at 4:20am

Yup, still.

 

--

David Rutten

david@mcneel.com

Poprad, Slovakia

• ▶ Reply