Grasshopper

algorithmic modeling for Rhino

Hey y'all, 

I am trying to Align the surface UV points so I could create structure grid that intersect on a floor slap. for some reason the UV points are tangent to the surface and it makes that UV points till up or down. please review the image below for more clarification. 

also I attached my .gh file for more reference.   

UV%20Problem.pdf

Views: 1441

Attachments:

Replies to This Discussion

Rebuild the surface with the countour curves (with loft), so the UV points will be more aligned.

This is because usually the surfaces created from curves, inherit the NURBS properties of those curves, and UV points are generated from these NURBS properties. So, you will need or rebuild the curves or rebuild the surface.

Attachments:

I made a script with a network surface as a uv product of the sweep surface and the contour lines. I am rebuilding lines to change the point population on v direction whereas the number of contours adjust the points in u direction.

Attachments:

Thank you so much dim gimi.... looks good to me 

RSS

About

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service