Grasshopper

algorithmic modeling for Rhino

Adding Springs to mesh surface (URGENT HELP PLEASE)

Hi everyone,

I am currently working with Kangaroo simulating fabric relaxation through surface springs derived from mesh edges.

I am wanting to add additional springs to the surface through drawing curves onto the surface. These springs will have different rest lengths etc. to the mesh edge springs, therefore causing the fabric to relax non-uniformly. (similar to edge cables, but they run through the fabric rather than around the perimeter)

I am having a lot of trouble adding these springs and my deadline has really crept up.

Below is an attempt to illustrate... Blue lines= Springs to add to mesh (Red).

I have attached the GH file if you can, please please help.

Thanks

Views: 1434

Attachments:

Replies to This Discussion

Hi

Why don't you use Andrew Heumann's fine base mesh solution in your previous post?

If you cannot find the use of someone's nice solution for you, then there are no one who could help you later on.

Anyway, check attached definition. You'll need K2 and "Meshedit" plug-in. Best.

Attachments:

RSS

About

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service