Grasshopper

algorithmic modeling for Rhino

About sweep 1

Hello, I'm making a project and I wanted to use the sweep 1 (as the script used here: http://www.grasshopper3d.com/forum/topics/sweeping-lines-in-grassho... ) baterie to add thickness with a rectangular section, but I can't find out whats wrong..I just wanted that the model in the 1st picture gained that thickness, but as it can be seen in the 2nd picture it didn't add the thickness very wel..The grashopper file is attached. Does anybody know how can I fix this?

1.jpg

2.jpg

Views: 378

Attachments:

Replies to This Discussion

Permalink Reply by Mohamed Naeim on May 16, 2016 at 8:59pm

Attachments:
Permalink Reply by giovanna moles on May 17, 2016 at 5:33am

I changed the script a little bit, but the edges still aren't meeting..

Attachments:
Permalink Reply by Mohamed Naeim on May 17, 2016 at 4:54pm

Attachments:
Permalink Reply by giovanna moles on May 17, 2016 at 5:00pm

Thank you so much, Mohamed!! You helped me a lot! (:

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service