Grasshopper

algorithmic modeling for Rhino

1. WbProcessingException: Two consecutive edges,

I get this error with Weaverbird occasionally... Where can I find Weaverbird's "Clean Up Mesh"?

1. WbProcessingException: Two consecutive edges, 2 and 0, have the same value,0, in face 4720. This topology is invalid. Try using Weaverbird's Clean Up Mesh first. - Weaverbird was unable to produce a valid result because of this

Views: 2130

Replies to This Discussion

Permalink Reply by David Stasiuk on May 5, 2015 at 2:57pm

Try either Daniel's "Combine&Clean" from Kangaroo or [UTO]'s Mesh WeldVertices from MeshEdit. This should help eliminate...

Permalink Reply by martyn hogg on May 5, 2015 at 4:28pm

Thanks!

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service